[CCMC 14051-R] CCMC Canadian code compliance evaluation

From: National Research Council Canada

In most jurisdictions this document is sufficient evidence for approval by Canadian authorities.

Learn more about CCMC recognition

Code compliance opinion

It is the opinion of the Canadian Construction Materials Centre that the evaluated product, when used as a waterproof membrane covering for decks and balconies that are subject to light pedestrian traffic in accordance with the conditions and limitations stated in this evaluation, complies with the following Canadian codes:

National Building Code of Canada 2010

Code provision Solution type
9.26.1.2.(1) Methods described in or are permitted ...Acceptable
9.26.2. Roofing MaterialsAlternative

The above opinion is based on the evaluation by the CCMC of technical evidence provided by the evaluation holder, and is bound by the stated conditions and limitations. For the benefit of the user, a summary of the technical information which forms the basis of this evaluation has been included.

  Product information

Product name

Decking Membrane

Product description

The product is a polyvinyl chloride membrane with a nominal thickness of 1.5 mm (nominal thickness of 2 mm with fleece backing). The product is made with a heat-set polyester fleece attached to the backside of the membrane. The surface of the product is embossed to provide a textured finish. The membrane is available in rolls that are 1.8 m wide and 23 m long. The product can be cut to required lengths. The product is available in a variety of colours.

Manufacturing plants

This evaluation is valid only for products produced at the following plants:

  • Mountain Top, Pennsylvania, United States

  Conditions and limitations

The CCMC’s compliance opinion is bound by this product being used in accordance with the conditions and limitations set out below.

  • The product must be used in conjunction with a continuous solid plywood or concrete substrate.
  • The membrane must be fully adhered to the substrate using the DURA PRO® – vinyl decking adhesive (AF0295), and applied as per the installation instructions.
  • The product is limited for use in areas that are subject to traffic loads generated by residential occupancies only (light pedestrian traffic).
  • The product must not be exposed to chemical attack or spillage. In situations where extended contact with chemicals or pollutants may occur, the suitability of the product must be determined.
  • Any physical or chemical damage to the membrane must be repaired in accordance with the manufacturer’s instructions.
  • The product is limited for use where the roof or deck surface has a minimum slope of 1:48.
  • The product must not be installed with butt seam joints.
  • Joints must be shingle-lapped in order to shed water.
  • The product must be installed by approved applicators only and in strict conformance with the current installation instructions.
  • The product or its packaging must be identified with the manufacturer’s name or logo and the phrase “CCMC 14051-R.”

  Technical information

This evaluation is based on demonstrated conformance with the following criteria:

Evaluation requirements
Criteria number Criteria name
CCMC-TG-075419.01-10Technical Guide for "PVC Sheet-Applied Waterproof Decking Membrane (Exposed to Light Pedestrian Traffic)"
Material requirements
Result of testing the material properties of the product
Property Unit Requirement Result
Overall thickness mm Report value 1.63
Overall thickness with fleece backing mm Report value 2.04

 

Performance of testing the performance properties of the product
Results of testing the performance properties of the product
Property Unit Requirement Result
Load strain properties - strain energy machine direction kN/m ≥ 30 54
cross-machine direction 50
Water vapour transmission g/m2/d ≤ 4.0 1.3
Water absorption mass % ≤ 3.0 2.9
Static puncture (rating) - ≥ 3.0 3
Dynamic puncture (rating) - ≥ 3.0 4
Low temperature impact original - 8 out of 10 pass 10 out of 10 pass
after weathering 10 out of 10 pass
Low temperature flexibility original - Material must not crack or exhibit any visible defects. Pass
after heat aging
after weathering
Lap joint strength – strain energy cross-machine direction original % Min. 75% of original membrane 82 (41 kN/m)
after heat aging Min. 70% of original membrane 78 (39 kN/m)
Abrasion resistance – original weight loss g ≤ 0.4 0.22
depth of water mm ≤ 0.30 0.18
Abrasion resistance – after accelerated weathering weight loss g ≤ 0.4 0.35
depth of water mm ≤ 0.30 0.26
Adhesion to substrate DURA PRO® – vinyl decking adhesive (AF0295) N ≥ 125 302
Slip resistance - dry condition (rating) leather - ≥ 0.50 0.57
rubber ≥ 0.70 0.74
Slip resistance - wet condition (rating) leather - ≥ 0.60 0.60
rubber ≥ 0.65 0.89

 

Administrative information

Disclaimer

This evaluation is issued by the Canadian Construction Materials Centre (CCMC), a part of the Construction Research Centre at the National Research Council of Canada (NRC). The evaluation must be read in the context of the entire CCMC Registry of Product Assessments and the legislated applicable building code in effect.

The CCMC was established in 1988 on behalf of the applicable regulator (i.e., the provinces and territories) to ensure—through assessment—conformity of alternative and acceptable solutions to regional building codes as determined by the local authority having jurisdiction (AHJ) as part of the issuance of a building permit.

It is the responsibility of the local AHJs, design professionals, and specifiers to confirm that the evaluation is current and has not been withdrawn or superseded by a later issue. Please refer to the website or contact:

Canadian Construction Materials Centre
Construction Research Centre
National Research Council of Canada
1200 Montreal Road
Ottawa, Ontario, K1A 0R6
Telephone: 613-993-6189
Fax: 613-952-0268

The NRC has evaluated the material, product, system or service described herein only for those characteristics stated herein. The information and opinions in this evaluation are directed to those who have the appropriate degree of experience to use and apply its contents (i.e., AHJs, design professionals and specifiers). This evaluation is only valid when the product is installed in strict compliance with the stated conditions and limitations of evaluation and the applicable local building code. In circumstances where no applicable local building permit is issued and that no confirmation of compliance ‘for use in the intended field application’ is undertaken, this evaluation is null and void in all respects. This evaluation is provided without representation, warranty, or guarantee of any kind, expressed, or implied, and the NRC provides no endorsement for any evaluated material, product, system or service described herein. The NRC accepts no responsibility whatsoever arising in any way from any and all use and reliance on the information contained in this evaluation with respect to its compliance to the referenced code(s) and standard(s). The NRC is not undertaking to render professional or other services on behalf of any person or entity nor to perform any duty owed by any person or entity to another person or entity.

Language

Une version française de ce document est disponible.
In the case of any discrepancy between the English and French version of this document, the English version shall prevail.

Copyright

© 2021 Her Majesty the Queen in Right of Canada, as represented by the National Research Council of Canada.

All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of the CCMC.

Date modified: