[CCMC 14051-R] CCMC Canadian code compliance evaluation
From: National Research Council Canada
In most jurisdictions this document is sufficient evidence for approval by Canadian authorities.Learn more about CCMC recognition Look for the trusted CCMC mark on products to verify compliance.
It is the opinion of the Canadian Construction Materials Centre that the evaluated product, when used as a waterproof membrane covering for decks and balconies that are subject to light pedestrian traffic in accordance with the conditions and limitations stated in this evaluation, complies with the following code:
National Building Code of Canada 2010
|ID||Code provision||Solution type|
|09-26-01-02-00-0-00||22.214.171.124.(1) Methods described in or are permitted ...||Acceptable|
|09-26-02-00-00-0-00||9.26.2. Roofing Materials||Alternative|
The above opinion(s) is/are based on the evaluation by the CCMC of technical evidence provided by the evaluation holder, and is bound by the stated conditions and limitations. For the benefit of the user, a summary of the technical information that forms the basis of this evaluation has been included.
Product descriptionThe product is a polyvinyl chloride membrane with a nominal thickness of 1.5 mm (nominal thickness of 2 mm with fleece backing). The product is made with a heat-set polyester fleece attached to the backside of the membrane. The surface of the product is embossed to provide a textured finish. The membrane is available in rolls that are 1.8 m wide and 23 m long. The product can be cut to required lengths. The product is available in a variety of colours.
This evaluation is valid only for products produced at the following plant:
|Product name||Manufacturing plant|
|Mountain Top, PA, US|
|Decking Membrane||Product evaluated by the CCMC|
Product evaluated by the CCMC Indicates that the product from this manufacturing facility has been evaluated by the CCMC
Conditions and limitations
The CCMC’s compliance opinion is bound by this product being used in accordance with the conditions and limitations set out below.
- The product must be used in conjunction with a continuous solid plywood or concrete substrate.
- The membrane must be fully adhered to the substrate using the DURA PRO® – vinyl decking adhesive (AF0295), and applied as per the installation instructions.
- The product is limited for use in areas that are subject to traffic loads generated by residential occupancies only (light pedestrian traffic).
- The product must not be exposed to chemical attack or spillage. In situations where extended contact with chemicals or pollutants may occur, the suitability of the product must be determined.
- Any physical or chemical damage to the membrane must be repaired in accordance with the manufacturer’s instructions.
- The product is limited for use where the roof or deck surface has a minimum slope of 1:48.
- The product must not be installed with butt seam joints.
- Joints must be shingle-lapped in order to shed water.
- The product must be installed by approved applicators only and in strict conformance with the current installation instructions.
- The product or its packaging must be identified with the manufacturer’s name or logo and the phrase “CCMC 14051-R.”
This evaluation is based on demonstrated conformance with the following criteria:
|Criteria number||Criteria name|
|CCMC-TG-075419.01-10||CCMC Technical Guide for "PVC Sheet-Applied Waterproof Decking Membrane (Exposed to Light Pedestrian Traffic)"|
|Overall thickness||mm||Report value||1.63|
|Overall thickness with fleece backing||mm||Report value||2.04|
Performance of testing the performance properties of the product
|Load strain properties - strain energy||machine direction||kN/m||≥ 30||54|
|Water vapour transmission||g/m2/d||≤ 4.0||1.3|
|Water absorption mass||%||≤ 3.0||2.9|
|Static puncture (rating)||-||≥ 3.0||3|
|Dynamic puncture (rating)||-||≥ 3.0||4|
|Low temperature impact||original||-||8 out of 10 pass||10 out of 10 pass|
|after weathering||10 out of 10 pass|
|Low temperature flexibility||original||-||Material must not crack or exhibit any visible defects.||Pass|
|after heat aging|
|Lap joint strength – strain energy cross-machine direction||original||%||Min. 75% of original membrane||82 (41 kN/m)|
|after heat aging||Min. 70% of original membrane||78 (39 kN/m)|
|Abrasion resistance – original||weight loss||g||≤ 0.4||0.22|
|depth of water||mm||≤ 0.30||0.18|
|Abrasion resistance – after accelerated weathering||weight loss||g||≤ 0.4||0.35|
|depth of water||mm||≤ 0.30||0.26|
|Adhesion to substrate||DURA PRO® – vinyl decking adhesive (AF0295)||N||≥ 125||302|
|Slip resistance - dry condition (rating)||leather||-||≥ 0.50||0.57|
|Slip resistance - wet condition (rating)||leather||-||≥ 0.60||0.60|
Use of Canadian Construction Materials Centre (CCMC) assessments
This assessment must be read in the context of the entire CCMC Registry of Product Assessments, any applicable building code or by-law requirements, and/or any other regulatory requirements (for example, the Canada Consumer Product Safety Act, the Canadian Environmental Protection Act, etc.).
It is the responsibility of the user to confirm that the assessment they are using is current and has not been withdrawn or superseded by a later version on the CCMC Registry of Product Assessments.
The National Research Council of Canada (NRC) has evaluated only the characteristics of the specific product described herein. The information and opinions in this evaluation are directed to those who have the appropriate degree of experience to use and apply its contents (such as authorities having jurisdiction, design professionals and specifiers). This evaluation is valid when the product is used as part of permitted construction, respecting all conditions and limitations stated in the evaluation, and in accordance with applicable building codes and by-laws.
This evaluation is provided without representation, warranty or guarantee of any kind, expressed or implied, and the NRC provides no endorsement for any evaluated product. The NRC accepts no responsibility whatsoever arising in any way from any and all use of or reliance on the information contained herein or the use of any evaluated product. The NRC is not undertaking to render professional or other services on behalf of any person or entity nor to perform any duty owed by any person or entity to another person or entity.
Une version française de ce document est disponible.
In the case of any discrepancy between the English and French version of this document, the English version shall prevail.
© His Majesty the King in Right of Canada, as represented by the National Research Council of Canada, 2023
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of the CCMC.